Determine the
condition and texture of hair by checking shafts, roots
and ends. Refer to diagnosis chart to identify what solutions
to apply to hair.
Step2
Pre-Shampoo Shampoo
hair to remove dirt and oil. Be sure not to scratch scalp
with nails
Step3
Pre-Treatment
Replenish damaged or dry hair by applying Amino Conc.
Step4
First Solution
Apply the appropriate solution chosen in Step 1 to hair
making sure to keep 1/2 inch away from the scalp.Leave solution
on hair according to the chart.
Step5
Checking
There are three different types of check testing all of
which must be done.
1. The Shaft - Tie the hair strand in a knot to check the
elasticity of the strand. If the knot stays in place then
the hair is ready for the next step. If the knot loosens
and comes undone the hair needs more processing time.
2. The Roots - Stretch the hair strand. If the hair stretches
like a rubber band it is ready. If it does not it needs
more processing time.
3. The Ends - Comb the hair all the way through from root
to end. If hair stays straight then it is ready. If hair
has a wave to it and moves then it needs more processing
time.
It is necessary to check every spot of hair. If necessary
re-apply solution to the hair but use a one step weaker
solution. Check hair at the minimum time for whichever
solution was chosen.
If hair has not softened, leave solution on until maximumtime.
Do not rinse off solution until it is ready. If it is
necessary to do so before hand then rinse and re-apply
the solution on the same hair.
Step6
Shampoo & Treatment
Apply Amino Wrap Shampoo to hair. Make sure it foams then
rinse off well. Be sure not to pull or
crumple hair. Gently towel dry. Apply mixture of Amino
Conc and Hair Pack Treatment all over the
hair. Do not rinse it off. Go to the next step.
Step7
Towel dry & Protect ends
Towel dry hair 60%. Apply Packing Essence to protect the
ends from heat.
Step8Winding
Take
a section of hair and wrap it around the rod. After each
rod is wrapped, place a rubber band around the rod. Depending
upon the width of curl desired, this will determine the
size of the section of hair and rod size used. Hair will
curl twice the size of the rod.
Step9Heat
Protection, Rod Cap and Connect the Rods & Wires to
the Machine. Place
heat protectors in between the rods and scalp. Place the
stopper in between the hair and rubber band. Place the
rod cap over the rod. Connect the machine wires to the
rods.
Step10
Heat Set up the timer and temperature and turn on machine.
After three minutes check rods to see if rods have heated
up. Heat should be used for 6 to 12 minutes depending upon
the type of hair. Coarse hair may take longer. When the
time is up, cool down for 5 to 7 minutes leaving the rods
in the hair. Unplug the wires and take off the rod caps,
heat protectors and stoppers.
Step11
Neutralizing
Apply the appropriate neutralizer all over the rods. Let
set for 5 to 7 minutes. Apply second coat of neutralizer.
Let set for 5 to 7 minutes.
Step12
Remove the Rods & Rince Remove the rubber bands and the rods. Rinse with
warm water. Condition with Amino Film Wrap Treatment.
Step13
Style Towel dry hair 70%. Apply Hair Body Up or Hair
Pack all over the hair depending on hair type. Take a big
section and twist it while blow drying to bring out the
curl. Continue process until hair is completely styled.
Shampoo
hair to remove dirt and oil. Be sure not to scratch scalp
with nails
